Hi there!👋

In this guide, you will learn how to connect any email address with SMTP/IMAP details as an email sender with SalesBlink to use in your cold email sequences. 📧

3. Enter the details as follows:

Your Name: This is your name as displayed to the receiver.
Sender Username: Your SMTP/IMAP username

Sender Email Address: Your SMTP/IMAP email address 📧
Sender Password: Your SMTP/IMAP password

SMTP Host: SMTP Host from your SMTP/IMAP Configuration
SMTP Port: SMTP Port from your SMTP/IMAP Configuration
IMAP Host: IMAP Host from your SMTP/IMAP Configuration
IMAP Port: IMAP Port from your SMTP/IMAP Configuration

Optionally, if you need to receive incoming emails (replies) to some other inbox, then you can check the box "Use Different Email Address for Incoming Emails" and enter the following details:

Receiver Email Address: Email Address where your replies should be sent.

Receiver Password / App Password: Password of the email addresses.
​

4. Hit "Next" and your email address will be connected. ✅

5. (optional) Set your email signature. ✏️

6. (optional) Enable Email Warmup 🔥for better deliverability.

7. (optional) Enable email sender in Unified Inbox. 📧

8. (optional) Set your custom domain for better email deliverability.

9. (optional) Check your domain setup. 💯

That's all, your email address is added as a sender now!

You can now use your SMTP/IMAP email address to launch cold emails sequences.

There are a couple of ways to go about this:

My credentials are correct but it won't connect.